Make a Jughead Hat

This hat uses the same pattern piece as the felt Jughead Hat, it just has a lining added and is made from some of my favorite hand dyed Hoffman fabrics.

Supplies Needed: 1/4" yard of hat fabric, 1/4" yard of lining fabric. Click HERE to download pattern piece. Print Jughead Hat Pattern at recommended percentage. Example: 100% will make a large adult size hat, 85% will make a hat that fits your average 10-year old. Trace paper pattern on fabric and cut four from each.

Step 1. Stitch the curved sides together of the four lining pattern pieces. Continue until all four pieces are attached together on all sides.

Step 2. Stitch the curved sides together of the hat pattern pieces. Continue until all four pieces are attached together on all sides.

Step 3. With the seam side up, press open the end of each seam so that it lies flat. Only the bottom half needs to lie flat, the top curve may be left alone. Continue pressing until the bottom of all four seams of the lining are pressed flat. Repeat step for all seams of hat.

Step 4. With the right sides facing each other, place the lining inside the hat. Match up the seams and pin in place.

Step 5. Stitch the crown edge up and down, all the way around the bottom. Trim very close to edge.

Step 6. With a seam ripper, open up about 2" on one seam of lining.

Step 7. Turn hat right side out through opening.

Step 8. Turn out crown points with seam ripper. Pull fabric out until all the points are clearly shown.

Step 8. Press edges flat with hot iron.

Step 9. Turn up 3" of bottom edge and press. Hand stitch inside hole opening in seam closed.

Step 10. Enjoy your new hat!